Welding on frames

Replies to This Discussion

Permalink Reply by Roach on July 8, 2009 at 12:35am

Just as long as your ground is right next to your welld, your fine, but what they say is a precausion and should be done.

...................Roach.

• ▶ Reply

Permalink Reply by Thespis on July 10, 2009 at 2:10pm

What Roach said...plus, disconnect the battery and remove it from the bike. It also pays to unplug the wiring to any electronics such as regulator/rectifiers, ignition modules etc. Have fun.

• ▶ Reply

Permalink Reply by Timber on July 24, 2009 at 5:40pm

yes you could fry the elec. out. same also applies to cars, trucks etc.. the big thing is you need to remove the cables to the battery. without the ground attached there wont be a route to you elec. from the welder.

• ▶ Reply

Permalink Reply by Rolf Schiphorst on November 12, 2010 at 6:31pm

main thing is that you release the negative cable from your battery after that you should be save

• ▶ Reply